[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Moose Z1100 Problems



Well I took apart the circuit boards as you detailed.  Sure enough,
the back side of the right sub-board is fried!  Black.  Toasted.  I
doubt any amount of solder & wire will be able to fix it, so it looks
like I need a new board.

I'd greatly appreciate any help finding a replacement sub-board.
Hopefully Mr. Rojas or Mr. Moose can help.  Also, it sounds like
another guy that replied may have on old one, if it's not fried, too.
(Or if he hasn't sold it as a boat anchor.)

Thanks!!!!
--Z



On Apr 6, 4:27 pm, "Robert L Bass" <no-sales-spam@bassburglaralarms>
wrote:
> > Also, the phone company had to
> > come and repair some lightning damage...
>
> Bingo!  That's almost certainly the problem.
> Here's how to find out.
>
> 1. Switch off the panel power using the
>  black slide switch on the lower left.
> 2. Loosen the four hex-nuts which hold
>  the main circuit board in place.
> 3. Remove the main circuit board by
>  gently pulling on both sides.
> 4. Remove the two small nuts which
>  hold the small right-hand circuit board
> in place.
> 5. Pull the board out and examine the
>  solder traces on the rear, close to the
>  top.  There are maze-like patterns of
>  solder there which act as sacrificial
>  fuses.  When lightning hits the phone
>  line these traces blow up instead of
>  the main circuit board.
>
> If the traces are blown you can follow
> the point where they break off and bypass
> them with a small wire.  Otherwise you
> have to replace the small circuit board.
> Unfortunately, they stopped making those
> boards years ago so swapping one out
> isn't an option (unless Jim Rojas has one
> in his garage).
>
> One possible other solution:  The original
> manufacturer, Moose Products was sold
> and the line eventually phased out.
> However, Wade Moose' new company,
> ELK Products might be able to source a
> replacement board.  If you can't get it
> fixed by Tuesday (this is Easter weekend)
> let me know and I'll ask if they can help.
>
> --
>
> Regards,
> Robert L Bass
>
> =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
=3D=3D=3D=3D=3D>
> Bass Home Electronics
> 941-925-8650
> 4883 Fallcrest Circle
> Sarasota =B7 Florida =B7 34233http://www.bassburglaralarms.com
> =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
=3D=3D=3D=3D=3D>




alt.security.alarms Main Index | alt.security.alarms Thread Index | alt.security.alarms Home | Archives Home