Re: Thanks

[Rapid <nosp@xxxxx>]

S. Smith wrote:
> We're dealing with an NX8V2.  I don't think my boss will ever change
> out the panel because of peripheral problems.  Hopefully I can convince
> him to buy the power supply (and not use another "junk board") to boost
> that.  I appreciate all ya'lls help.  After 3 hours in a hot ass
> warehouse staring up at wire and wondering why motions don't work, I
> needed some inspiration.  You guys came through.  Thanks!
>
so you're saying you have a GE NX8V2 panel and an ademco panel as a
power supply for the motions?
First thing I would do is power the motions from the panel.  With a 40Va
xfrmer you got 1 amp.  If that is not enough you can add a NX320E for
antoher 2 amps that will be supervised by the NX8.
Others have had some good suggestions about zoning these onto separate
zones and you need to figure power to see if larger guage wire is
needed.  If so could be excuse to run some new wire to help in zoning
these out.