Re: Power DCS 632 Help

["Doug L" <vssdoug@xxxxxxx>]

Either that or read the manual first

Doug

--

"Jim Rims" <jrims@xxxxxxxxx> wrote in message
news:r4RAg.18441$Nv.5154@xxxxxxxxxxxxx
> Guys, I've reset everything again so if anyone has any ideas let me know.
> If not I will just return it to www.homesecuritystore.com where I bought
> it. Thanks.
>
>
>
> "Jim Rims" <jrims@xxxxxxxxx> wrote in message
> news:jrQAg.18440$Nv.2491@xxxxxxxxxxxxx
>> The receiver is a RF5501-433 receiver and I am using 433 detectors but
>> still can't get it to go.  I even just reset the whle damm system and
>> redid everything.  I did activate my test zones, 01,02,03 as wireless,
>> all three are acting as 03 defintiions.  What I did do is activate zone 2
>> as wireless but did not assign a detector to it.  When I go to test my
>> zones and I try 01 and 03 where I do have an ESN assigned the screen just
>> sits there, shows the zone number and lights up ready and armed.  When I
>> try zone two which does not have an esn assigned it won't allow me to
>> select it.  The book says that good is light 1 on steady...what ever the
>> hell that means and that light 3 on steady is bad.  Help!!!!!
>>
>> "tourman" <rh.campbell@xxxxxxxxxxxxx> wrote in message
>> news:1154732056.517171.266590@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>>> Are you sure you're not trying to enroll 433 mhz equipment on a 900
>>> receiver, or visa versa...easy to do (don't ask me how I know)
>>>
>>> Jim Rims wrote:
>>>> Ok, about to yank my hair out.  632 system and I can't get wireless
>>>> door
>>>> contacts to work (or test).
>>>>
>>>> Docs tell me I can only use zones 9-32 for wireless.  Ok, I did the * 8
>>>> [installer code] 002 and changed the defintions of zones 9-16 to [01]
>>>> dealy
>>>> 1 zone.
>>>>
>>>> I can't get any of the detectors to work using the *8 [installer code]
>>>> 904
>>>> and testing zone 9.  I already went in and used *8 [installer code]
>>>> 804,
>>>> entered zone 09 and then entered the ESN and still no luck.
>>>> Help!!!!!!!!!!!!!
>>>
>>
>>
>
>