Re: Power DCS 632 Help

["Everywhere Man" <alarminstall@xxxxxxx>]

This may be the beginning of a parade, Doug.
Someone likes to do this to his online competitors.


Doug L wrote:
> Either that or read the manual first
>
> Doug
>
> --
>
> "Jim Rims" <jrims@xxxxxxxxx> wrote in message
> news:r4RAg.18441$Nv.5154@xxxxxxxxxxxxx
> > Guys, I've reset everything again so if anyone has any ideas let me know.
> > If not I will just return it to www.homesecuritystore.com where I bought
> > it. Thanks.
> >
> >
> >
> > "Jim Rims" <jrims@xxxxxxxxx> wrote in message
> > news:jrQAg.18440$Nv.2491@xxxxxxxxxxxxx
> >> The receiver is a RF5501-433 receiver and I am using 433 detectors but
> >> still can't get it to go.  I even just reset the whle damm system and
> >> redid everything.  I did activate my test zones, 01,02,03 as wireless,
> >> all three are acting as 03 defintiions.  What I did do is activate zone 2
> >> as wireless but did not assign a detector to it.  When I go to test my
> >> zones and I try 01 and 03 where I do have an ESN assigned the screen just
> >> sits there, shows the zone number and lights up ready and armed.  When I
> >> try zone two which does not have an esn assigned it won't allow me to
> >> select it.  The book says that good is light 1 on steady...what ever the
> >> hell that means and that light 3 on steady is bad.  Help!!!!!
> >>
> >> "tourman" <rh.campbell@xxxxxxxxxxxxx> wrote in message
> >> news:1154732056.517171.266590@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> >>> Are you sure you're not trying to enroll 433 mhz equipment on a 900
> >>> receiver, or visa versa...easy to do (don't ask me how I know)
> >>>
> >>> Jim Rims wrote:
> >>>> Ok, about to yank my hair out.  632 system and I can't get wireless
> >>>> door
> >>>> contacts to work (or test).
> >>>>
> >>>> Docs tell me I can only use zones 9-32 for wireless.  Ok, I did the * 8
> >>>> [installer code] 002 and changed the defintions of zones 9-16 to [01]
> >>>> dealy
> >>>> 1 zone.
> >>>>
> >>>> I can't get any of the detectors to work using the *8 [installer code]
> >>>> 904
> >>>> and testing zone 9.  I already went in and used *8 [installer code]
> >>>> 804,
> >>>> entered zone 09 and then entered the ESN and still no luck.
> >>>> Help!!!!!!!!!!!!!
> >>>
> >>
> >>
> >
> >