Re: Power DCS 632 Help

["Jim Rims" <jrims@xxxxxxxxx>]

Guys, I've reset everything again so if anyone has any ideas let me know.
If not I will just return it to www.homesecuritystore.com where I bought it.
Thanks.



"Jim Rims" <jrims@xxxxxxxxx> wrote in message
news:jrQAg.18440$Nv.2491@xxxxxxxxxxxxx
> The receiver is a RF5501-433 receiver and I am using 433 detectors but
> still can't get it to go.  I even just reset the whle damm system and
> redid everything.  I did activate my test zones, 01,02,03 as wireless, all
> three are acting as 03 defintiions.  What I did do is activate zone 2 as
> wireless but did not assign a detector to it.  When I go to test my zones
> and I try 01 and 03 where I do have an ESN assigned the screen just sits
> there, shows the zone number and lights up ready and armed.  When I try
> zone two which does not have an esn assigned it won't allow me to select
> it.  The book says that good is light 1 on steady...what ever the hell
> that means and that light 3 on steady is bad.  Help!!!!!
>
> "tourman" <rh.campbell@xxxxxxxxxxxxx> wrote in message
> news:1154732056.517171.266590@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> Are you sure you're not trying to enroll 433 mhz equipment on a 900
>> receiver, or visa versa...easy to do (don't ask me how I know)
>>
>> Jim Rims wrote:
>>> Ok, about to yank my hair out.  632 system and I can't get wireless door
>>> contacts to work (or test).
>>>
>>> Docs tell me I can only use zones 9-32 for wireless.  Ok, I did the * 8
>>> [installer code] 002 and changed the defintions of zones 9-16 to [01]
>>> dealy
>>> 1 zone.
>>>
>>> I can't get any of the detectors to work using the *8 [installer code]
>>> 904
>>> and testing zone 9.  I already went in and used *8 [installer code] 804,
>>> entered zone 09 and then entered the ESN and still no luck.
>>> Help!!!!!!!!!!!!!
>>
>
>