Re: FCI 7100

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

I would also think..that if it were a known problem (manny suggests for 2
years) that a tech bulletin should have gone out to every dealer informing
them of the problem AND the fix. Sounds like there are some butts hanging in
the wind here.




"Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
news:nsPTe.349$3B2.24@xxxxxxxxxxx
> How the hell does FCI get away with this?  Any other manufacturer would
> probably lose their UL Listing for lesser reasons.
>
> Though I am not an FCI dealer...we weren't too far off from what the
> gentleman described his problems were. If you are correct, then the
> manufacturer is totally responsible, and should overnight a new panel to
> remedy the situation quickly. If they fail to comply, contact UL and
> document everything.
>
> Jim Rojas
>
>
>
> "manny" <makusafe@xxxxxxx> wrote in message
> news:Xns96CB6C639E58makusafemsncom@xxxxxxxxxxxxxxxxx
>> None of these people no the problem, as none of the are dealers for FCI,
>> I
>> have been dealing with this issue for almost two years, some panels just
>> lock up with a comm error, the problem is with the dialer part of the
>> Panel,
>>
>> The FCI 7100 has a seriuos problems with firmware, when using the built
>> in
>> DACT. Check to see what revision you running, the latest release is 6.3
>> for
>> the main eprom.
>> I recommend you get the dealer to replace the Panel or upgrade you
>> revision
>> to 6.3
>
>