Re: Ademco:PanelDumpsCentralStation

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

I have one 20P that just refuses to talk to Compass..driving me nuts.
Telco voltage 52v - can't tell abt noise...at least it doesnt sound noisy.
*96'd it 3 times
I even had Ademco try to connect and they get the same error.
I have a feeling that they sold me a mislabeled proprietary panel but they
say; no.
We even disconnected every phone on the premises...no go.

The only thing I can figure is that it's on a podunk baby phone co. system
out in the boonies - but even that doesn't make too much sense cause I've
talked to other panels in the same area without a problem.


<thesatguy1@xxxxxxxxxxxxx> wrote in message
news:oCT%e.37$dB4.35@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
| The password is wrong and the panel will hang up every time.
|
| "Don" <dgp0@xxxxxxxxxxxxx> wrote in message
| news:1128216006.581040.242190@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
| > Hello to All,
| > 01 Problem: Ademco 50P panel dumps central station immediately after
| > answering their dial in for setup.
| >
| > 02 Background: self-installed.  1 Ademco 50p panel; 1 12-volt, 7-amp
| > battery at auxiliary power; 1 4208U expansion cards, currently.
| >
| > 03 Currently connected: 2 2-wire heat, 1 4-wire CO, 12 4-wire smokes.
| > 10K EOL resistors are wired at each detector rather than in the panel
| > and expansion card. The first 8 detectors are wired directly to the
| > panel, jumper wired at zone 9,  next 7 (10-16) to the expansion.
| >
| > No problem indicated at keypad.
| >
| > 04 I may have programmed something at the keypad called Jumper. I have
| > to find it again.
| >
| > 05  My panel is in New York City. Called internet monitoring service,
| > central station in California.  Programmed their numbers while they
| > instructed over separate telephone line.  When they dial into the
| > Vista-50p over its own hardwired, dedicated telephone line, the panel
| > seems to negotiate with their modem then immediately hangs up.
| >
| > NY telco says the line is noiseless which it does seem to be.  Ademco
| > dialed in at request of central station and said the communicator was
| > bad.  I bought and installed a whole new panel! Problem persisted.
| > Local installer said I had to use an RJ31X so I installed one.  Problem
| > still persists.  Central Station never heard of this problem.  Three
| > local installers also never heard of it.  Ademco/Honeywell will not
| > talk to me.
| >
| > I am up against a deadline from my insurer to have this system
| > monitored.
| >
| > Any and all help is appreciated... and desperately needed.
| >
| > TIA
| >
| > Don
| >
|
|
|