Re: Radionics D7212B1 Panel Help

["Jim Rojas" <jrojas@xxxxxxxxxxxx>]

It's not that bad... :)

Jim Rojas

"Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
news:x7qdnYANHKB7acfeRVn-1w@xxxxxxxxxxxxxx
> Oh god walk away from it please........
>
> "WYSIWYG" <nospam@xxxxxxx> wrote in message
> news:kcC6f.1255$8W.22@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> Crash,
>>
>> Thanks for the reply.
>> I'm pretty handy with a soldering iron so I think the board hardware is
> OK.
>> Really depends on Radionics' software design as to if any "magic" needs
>> to
>> be retained in the RAM to make things work. If so, I'm sure it was blown
>> away years ago.
>>
>> So I understand I must have a 5200 programmer to initialize the board?
>> I see 5200 programmers on sale on ebay all the time. What "product
> handlers"
>> would I need to fully program the board?
>> Are there no other tools to program these boards?
>> Is the command set to the board documented anywhere?
>> Is it normal that an uninitialized board would not talk to a D1255
>> controller? If I get it talking to the controller, can I program
> everything
>> from it?
>>
>> While I'm firing off questions, I also purchased a few OCTPOPITS D8128A.
> The
>> documentation is contradictory regarding which versions of these A,B,C,
>> or
> D
>> are compatible with this panel. What were the differences between these
>> revisions?
>>
>> Sorry for all the questions. I'm eager to get this thing working.
>>
>> Thanks again for any help.
>>
>> Bob
>
>