Re: Radionics D7212B1 Panel Help

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

yah they were.
they're one of the reasons I only service radx now...who needs a panel with
a 90 page programming "sheet"?


"Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
news:QFC6f.656$585.132@xxxxxxxxxxx
| It's not that bad... :)
|
| Jim Rojas
|
| "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
| news:x7qdnYANHKB7acfeRVn-1w@xxxxxxxxxxxxxx
| > Oh god walk away from it please........
| >
| > "WYSIWYG" <nospam@xxxxxxx> wrote in message
| > news:kcC6f.1255$8W.22@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
| >> Crash,
| >>
| >> Thanks for the reply.
| >> I'm pretty handy with a soldering iron so I think the board hardware is
| > OK.
| >> Really depends on Radionics' software design as to if any "magic" needs
| >> to
| >> be retained in the RAM to make things work. If so, I'm sure it was
blown
| >> away years ago.
| >>
| >> So I understand I must have a 5200 programmer to initialize the board?
| >> I see 5200 programmers on sale on ebay all the time. What "product
| > handlers"
| >> would I need to fully program the board?
| >> Are there no other tools to program these boards?
| >> Is the command set to the board documented anywhere?
| >> Is it normal that an uninitialized board would not talk to a D1255
| >> controller? If I get it talking to the controller, can I program
| > everything
| >> from it?
| >>
| >> While I'm firing off questions, I also purchased a few OCTPOPITS
D8128A.
| > The
| >> documentation is contradictory regarding which versions of these A,B,C,
| >> or
| > D
| >> are compatible with this panel. What were the differences between these
| >> revisions?
| >>
| >> Sorry for all the questions. I'm eager to get this thing working.
| >>
| >> Thanks again for any help.
| >>
| >> Bob
| >
| >
|
|
|