Re: Question on Programming DCS PC5010

["Jim Rojas" <jrojas@xxxxxxxxxxxx>]

The data somehow got corrupted during the transfer. It's not uncommon.

Jim Rojas


"TxNative" <TxNative@xxxxxxxxxxx> wrote in message
news:Khf_d.23522$YD4.22534@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Thanks for the help Jim.
> As you suggested, I reset everything and reprogrammed.
> Now there is no error message. Not sure what was causing the error earlier
> but it is gone now. I have compared printouts of both files and I can't
> find any difference in the programming.
> Thanks again for the help.
>
>
> "Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
> news:fG4_d.9269$Z07.702@xxxxxxxxxxx
>> Give me a call. I can help you out better that way.
>>
>> Jim Rojas
>> (813) 884-6335 Cell
>>
>>
>> "TxNative" <TxNative@xxxxxxxxxxx> wrote in message
>> news:ol4_d.12771$WK2.9941@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>>> Thanks for the help.
>>>
>>> When I look at the "User Access Code" list, there is no code shown for
>>> Part 1 Master. When I input a code for Part 1 Master it shows up as
>>> Access Code #41 on the error log.
>>>
>>> Could Access Code #40 be the "System Master" access code?
>>>
>>> In the User Access Code List the box to the right of Systerm Master
>>> indicating Partition 1 is marked NO. However, it is grayed out and I
>>> can't get it to allow me to change it to YES.
>>>
>>> If this is the code giving me the problem, I have been unable to find
>>> where to enable it for Part 1.
>>>
>>> "Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
>>> news:h34_d.4363$UV2.1078@xxxxxxxxxxx
>>>> Code 40 is the partition 1 master code.
>>>>
>>>> Next to the user code you will see a few check boxes. Make sure
>>>> partition one is selected.
>>>>
>>>> Jim Rojas
>>>>
>>>>
>>>> "TxNative" <TxNative@xxxxxxxxxxx> wrote in message
>>>> news:5W3_d.16025$yp.4215@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>>>>> Programming a DCS PC5010 using DLS. Getting an error message "Access
>>>>> code #40 has been programmed but is not assigned to any partition".
>>>>> The only codes currently programmed are the Installer Code, Master
>>>>> Code, and Downloading Access Code.
>>>>> There are no User Access codes programmed.
>>>>> What code is Access Code #40 ?
>>>>> Any ideas on why I am getting the error?
>>>>>
>>>>> Thanks
>>>>>
>>>>
>>>>
>>>
>>>
>>
>>
>
>