Re: Question on Programming DCS PC5010

["Jim Rojas" <jrojas@xxxxxxxxxxxx>]

Give me a call. I can help you out better that way.

Jim Rojas
(813) 884-6335 Cell


"TxNative" <TxNative@xxxxxxxxxxx> wrote in message
news:ol4_d.12771$WK2.9941@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Thanks for the help.
>
> When I look at the "User Access Code" list, there is no code shown for
> Part 1 Master. When I input a code for Part 1 Master it shows up as Access
> Code #41 on the error log.
>
> Could Access Code #40 be the "System Master" access code?
>
> In the User Access Code List the box to the right of Systerm Master
> indicating Partition 1 is marked NO. However, it is grayed out and I can't
> get it to allow me to change it to YES.
>
> If this is the code giving me the problem, I have been unable to find
> where to enable it for Part 1.
>
> "Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
> news:h34_d.4363$UV2.1078@xxxxxxxxxxx
>> Code 40 is the partition 1 master code.
>>
>> Next to the user code you will see a few check boxes. Make sure partition
>> one is selected.
>>
>> Jim Rojas
>>
>>
>> "TxNative" <TxNative@xxxxxxxxxxx> wrote in message
>> news:5W3_d.16025$yp.4215@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>>> Programming a DCS PC5010 using DLS. Getting an error message "Access
>>> code #40 has been programmed but is not assigned to any partition".
>>> The only codes currently programmed are the Installer Code, Master Code,
>>> and Downloading Access Code.
>>> There are no User Access codes programmed.
>>> What code is Access Code #40 ?
>>> Any ideas on why I am getting the error?
>>>
>>> Thanks
>>>
>>
>>
>
>