Re: Question on Programming DCS PC5010

["TxNative" <TxNative@xxxxxxxxxxx>]

Thanks for the help.

When I look at the "User Access Code" list, there is no code shown for Part
1 Master. When I input a code for Part 1 Master it shows up as Access Code
#41 on the error log.

Could Access Code #40 be the "System Master" access code?

In the User Access Code List the box to the right of Systerm Master
indicating Partition 1 is marked NO. However, it is grayed out and I can't
get it to allow me to change it to YES.

If this is the code giving me the problem, I have been unable to find where
to enable it for Part 1.

"Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
news:h34_d.4363$UV2.1078@xxxxxxxxxxx
> Code 40 is the partition 1 master code.
>
> Next to the user code you will see a few check boxes. Make sure partition
> one is selected.
>
> Jim Rojas
>
>
> "TxNative" <TxNative@xxxxxxxxxxx> wrote in message
> news:5W3_d.16025$yp.4215@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> Programming a DCS PC5010 using DLS. Getting an error message "Access code
>> #40 has been programmed but is not assigned to any partition".
>> The only codes currently programmed are the Installer Code, Master Code,
>> and Downloading Access Code.
>> There are no User Access codes programmed.
>> What code is Access Code #40 ?
>> Any ideas on why I am getting the error?
>>
>> Thanks
>>
>
>