Re: relocate existing alarm panel.

[James Russo <jr@xxxxxxxxxxxxxxxx>]

I've ordered the zone expander and am going to go with the suggestion
from Frank. The home has 17 sensors total and many would be combined
since they are on the same window or in the same room. With this route
it's one cat5e to the original panel and then all the zone configuration
is done via the wiring in that panel. It will also keep the structured
wiring panel alot cleaner..

regards,

-jr

Bob La Londe wrote:
> I used to be all anal about keeping my zones neatly ordered, but I found I
> was just wasting time on tie downs, and I still had to look at my
> documentation for the zones to determine which one was which when trouble
> shooting.
>
> When using panels with EZMs I like to organize things to allow for short
> easy wire pulls that leave a couple zones open, but terminated on each
> module.  This makes additions later a snap as well.
>
> Look at your total number of zones and the configuration to determine if you
> will have any headaches.
>
> (never used and M1)
>