Re: Adding a third keypad to a Caddx NX-8, wiring help requested!

["Russell Brill" <russwbrill@xxxxxxxxxxxxx>]

Oh my God........ I surprised the system didn't pick up every source of RF
in the neighborhood and generate False Alarms daily...

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:3D5Oe.42$Ox3.12849@xxxxxxxxxxxxxxxxxx
>I re-did a house several years back..the whole house was run under-carpet
>with that OLD flat 300 ohm TV antenna wire...remember that stuff...what a
>crappy install that was!
>
>
> "Russell Brill" <russwbrill@xxxxxxxxxxxxx> wrote in message
> news:UQ1Oe.8842$Wi6.5276@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> ha ha ha ha............
>>
>> "Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
>> news:310Oe.5$FY6.1901@xxxxxxxxxxxxxxxxxx
>>>I use 12ga Romex for all my window contacts so I never  have a problem
>>>with breakage.
>>>
>>>
>>> <cctvbahamas@xxxxxxxxxxx> wrote in message
>>> news:1124604332.030690.217730@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>>>> why is everyone talking about using twisted pair for alarm hardware ...
>>>> ??
>>>>
>>>> Telco wire is all yah need .. :-)
>>>>
>>>> Never had an issue with keypads using Telco wire, besides the
>>>> occasional one that would give an issue at time of installation where
>>>> the solid 24AWG wire would break after bending it a couple times ...
>>>> and was fixed then and never had a problem again.
>>>>
>>>> Its not like you are sending video ... just keep away from high
>>>> voltage..
>>>>
>>>
>>>
>>
>>
>
>