Re: Adding a third keypad to a Caddx NX-8, wiring help requested!

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

I re-did a house several years back..the whole house was run under-carpet
with that OLD flat 300 ohm TV antenna wire...remember that stuff...what a
crappy install that was!


"Russell Brill" <russwbrill@xxxxxxxxxxxxx> wrote in message
news:UQ1Oe.8842$Wi6.5276@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> ha ha ha ha............
>
> "Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
> news:310Oe.5$FY6.1901@xxxxxxxxxxxxxxxxxx
>>I use 12ga Romex for all my window contacts so I never  have a problem
>>with breakage.
>>
>>
>> <cctvbahamas@xxxxxxxxxxx> wrote in message
>> news:1124604332.030690.217730@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>>> why is everyone talking about using twisted pair for alarm hardware ...
>>> ??
>>>
>>> Telco wire is all yah need .. :-)
>>>
>>> Never had an issue with keypads using Telco wire, besides the
>>> occasional one that would give an issue at time of installation where
>>> the solid 24AWG wire would break after bending it a couple times ...
>>> and was fixed then and never had a problem again.
>>>
>>> Its not like you are sending video ... just keep away from high
>>> voltage..
>>>
>>
>>
>
>