Re: Newbie help - Caddx NX8e fire alarm reset

[joe <nospam@xxxxxx>]

Russell Brill wrote:
> If you haven't changed any user codes, try entering "1234" (Default User
> Master Code) to silence the trouble condition, or enter whatever you've
> chosen for a User Master Code... BTW: you cannot be in programming mode and
> cancel alarms/troubles at the same time... Regards, Russ
>
> "Wambro" <wambro01@xxxxxxxxx> wrote in message
> news:1123208595.709552.183220@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
>>Hello,
>>I decided to jump into installing my own system in my new home and was
>>bench testing a smoke (DSC FSA-410BST).  I tripped the system for fire
>>on the bench and then shut it down by simply pulling the plug.  Now
>>when I installed the panel in the home plus the 10 DSA smokes (EOL
>>relay plus prm-4W module) in sequence and hooked it all up, the panel
>>keeps flashing "Fire" and Zone 8 trouble.  It is also annoying in that
>>the sounder inside the keypads (both are LCD pads) keeps going off and
>>is only silenced temporarily by pressing a key.  I did a panel reset
>>(*8, 9713, 910#), but nothing seems to reset the "fire" condition.  How
>>the heck do I reset this?  Thanks!
>>
>
>
>


after 1234 to silence as Russ points out then press *7 to reset