Re: Lighting

[Stuart Grimshaw <stuart@xxxxxxx>]

On Fri, 2003-01-31 at 09:41, umar@xxxxxxx wrote:
> > > If you use x10 then how do you trigger the lights via
switches ?? Can
> > you
> > > connect low voltage wiring to the ld11 inputs??? or is it
240v
> > > trigger.......??
> > 
> > !!! You cannot use cat5 for the switch inputs to LD11's !!!
> > 
> Normal twin and earth cable from momentary switch to LD11 I assume. I
would put cat 5 next to each switch for future proofing if I dont go down
CBUS route.

yes, though the cat5 has to be seperated from the t&e by a certain
distance, your sparky should know that, though I'm sure some helpfull
list member will tell you ...


-- 
Stuart Grimshaw <stuart@xxxxxxx>

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.