> > If you use x10 then how do you trigger the lights via switches ??
Can
> you
> > connect low voltage wiring to the ld11 inputs??? or is it 240v
> > trigger.......??
>
> !!! You cannot use cat5 for the switch inputs to LD11's !!!
>
Normal twin and earth cable from momentary switch to LD11 I assume. I would
put cat 5 next to each switch for future proofing if I dont go down CBUS
route.
http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.