Re: All zones showing fault (NX-8E), please help

[NeonTide <aaron.harley@xxxxxxxxx>]

On May 14, 1:51 am, Frank Olson <Use-the-email-
li...@xxxxxxxxxxxxxxxxxxxxxx> wrote:
> NeonTide wrote:
> > Hi all!  I have a Caddx NX-8E with NX-216E Zone Expansion module and
> > two NX-148E keypads.  I have programed the system using the DL900
> > software, but every zone (21 of them) are showing fault.  I'm not sure
> > if I've missed something in the setup or what.  Any thoughts/
> > suggestions would be greatly appreciated.  I have put EOL Resistors on
> > all unused zones and have turned off box tampering as well.
>
> It all depends on how you've connected your circuits.  If you haven't
> used the supplied EOL resistors, then you have to program the panel for
> "No EOL".

Thank you very much for your help.  I found out where to turn off the
EOL in the DP900 software.  Now everything works great!