Re: HAI outputs - Garage Door Opener

[daisycutter@xxxxxxxxxxxxx]

On Thu, 30 Sep 2004 22:17:10 -0500, in comp.home.automation you wrote:
Easyest thing to do is get a power flash module.
www.smarthome.com/2010.html  you can try here but  don't like buying
from them .  They are to expensive.  Anyway, this way you don't have
to run any new wiring, just set an address and tell omni what to do.On
Thu, 30 Sep 2004 22:17:10 -0500, G. Morgan
<alarmproSNAIL@xxxxxxxxxxxxxx> wrote:

>Someone named "A Bazin" <bsci@xxxxxxxxx>  Proclaimed on Fri, 01 Oct
>2004 00:14:44 GMT,
>
>>What should I look for when buying a dry-contact relay?  Where can I get
>>one...Radio Shack?
>
>
>Your panel provides a 12V output.  I looked at the installation
>instructions, and there is no dry contact on that panel.  What you
>need is Radio Shack PN 275-206.  Hook up the output #1 and a common on
>your panel to the coil of the relay.  Hook the garage door button to
>one of the contacts NO/common.  Someone else told you to program the
>output for 2 seconds, sounds good to me. Also I assume you're
>programming it as type zero, "general purpose", right?
>
>The relay has an extra set of contacts, if you find a need for
>something else in the garage that requires a 'momentary' contact open
>or close you'll have it.
>
>Good luck.
>