[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: programming with CM15A & motion sensors

Subject: Re: programming with CM15A & motion sensors
From: Joerg <notthisjoergsch@xxxxxxxxxxxxxxxxxxxxx>
Date: Fri, 26 Aug 2005 23:53:03 GMT
Newsgroups: comp.home.automation
References: <1125071606.861817.249940@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>

Hi Paul,

> I've got an ActiveHome CM15A USB interface device - does anyone know if
> it can be programmed with anything besides the ActiveHome Pro SDK? More
> specifically, I'm trying to write some software that can either receive
> signals from a wireless motion sensor, or query the sensor for its
> current state. Is that possible?

As Dave said, the sensors are xmit only. But what if you would let the
sensor signal start a CM15A macro? Then the event would be captured.

Regards, Joerg

http://www.analogconsultants.com

Follow-Ups:
- Re: programming with CM15A & motion sensors
  - From: Dave Houston

References:
- programming with CM15A & motion sensors
  - From: ptepper

Prev by Message: Re: OT: Advice on Good Online Store Setup
Next by Message: Mounting PIR's outside
Previous by thread: Re: programming with CM15A & motion sensors
Next by thread: Re: programming with CM15A & motion sensors
Index(es):
- Message
- Thread

comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home