Re: Napco Gemini P3200 area?

[Jim <alarminex@xxxxxxx>]

On Friday, October 23, 2015 at 1:06:27 AM UTC-4, spyros wrote:
>=20
> Finally i did it :)
> From quickloader i can arm/disarm etc but from the keypad i can only arm =
in interior mode and i can not disarm! while pressing 1234 on/off to disarm=
 from interior mode, i get message **ENTER NOW** and the keybad beeps fro a=
bout 5 sec
> Any idea? At away mode (1234 on/off) nothing happens....
> confused :(

Hi Spyros,

The ""Enter Now"" should only show up if a code has been entered for access=
 control. If You look at the Keypad you will see a brown wire. That wire ca=
n be activated as a door access control output. I have mag lock doors in bu=
sinesses that can be controlled by employees returning during the day when =
they enter a code at the keypad. It doesn't arm the panel, only releases th=
e mag lock on the door.

You apparently have a code programmed in the panel to be used for access co=
ntrol.  The only problem I can't account for is that the **Enter Now** shou=
ld only appear after you enter the code and then go away after a minute or =
so. Look in the panel programming for anything to do with access control an=
d erase it and download to the panel. Look in the area of programming where=
 you enter the user codes. If you don't see it on the first screen, scroll =
all the way down to the bottom. Someone may have made the access code user =
# 32. If after you download to the panel no change occurs, de-power the pan=
el and then start it up again. Sometimes troubles get locked into memory an=
d if you don't clear them before you change programming the trouble stays l=
ocked in memory until you power down the panel.=20