Re: Trying to wrap my head around it

[JoeRaisin <joeraisin2001@xxxxxxxxx>]

On 10/22/2011 5:17 PM, mleuck wrote:
> On Oct 21, 3:23 am, G. Morgan<G_Mor...@xxxxxxxx>  wrote:
>> mleuck Wrote:
>>
>>> On Oct 20, 7:14 am, G. Morgan<G_Mor...@xxxxxxxx>  wrote:
>>>> Jim Rojas Wrote:
>>
>>>>> ADT has their own variation of CID codes in these panels. It sounds like
>>>>> a bug.
>>
>>>> And who are they to redefine CID for proprietary panels?  What a joke.
>>
>>> It would be a joke if they did it which they don't
>>
>> Not the last time I looked.  I know they have "extended" codes for
>> proprietary use on new-gen panels, but not on a SW/3000 over a dozen
>> years old.
>
> Extended codes yes but redefining old codes no, besides the 3000 is a
> Vista-20P and one can go into the configurable zone section and
> reprogram zones to send anything

This one wasn't programmed as a configurable zone - simple entry/exit.

Mark, been meaning to ask you something but I'm not sure if I remember
something right.  I think I have seen posts in the past indicating you
may have some knowledge of ADT systems.

I can't figure out what point type a motion detector should be on a
Focus panel.  There is no "interior follower" or anything that seems
like one.  The ADT techs I have asked say they just make them either
delayed or instant perimeter types based on where they are.

Why do they have to rename stuff?