Re: Changing User Access Code on Ademco Vista 20P

[mleuck <m.leuck@xxxxxxxxx>]

On Aug 10, 5:59=A0pm, CH=AEIS <s...@xxxxx> wrote:
> "mleuck" wrote...
>
> On Aug 5, 2:24 am, CH=AEIS <s...@xxxxx> wrote:
>
> > > This is one area where even a DSC Maxsys is easier to work with...
> > > You need that code to be a master code? Done.
> > > You need this code to be able to access only partitions 1, 4, 7 and 8=
?
> > > No
> > > problem.
> > > You'd like me to program those now at the keypad instead of getting o=
ne
> > > of
> > > the alpha keypads, ladder, etc. out of the van; wiring it to your pan=
el;
> > > getting it addressed; then programming? No problem.
>
> > Spend 40 to 45 minutes uploading the Maxsys? check! :)
>
> Well you do have a point there. =A0Although if you're doing it by PC-Link
> instead of the modem it's much faster, perhaps a couple minutes (5?). =A0=
I
> never have used Compass though.

Its a lot quicker uploading a Vista-250 with Compass than a 4020 using
DLS-2002 however the Vista doesn't have 999 user codes either :)