Re: Vista 20 and IR motion problem

["Doug" <not@xxxxxxxx>]

<rickm@xxxxxxxxxxxxxx> wrote in message
news:a2a1fd80-bd10-409d-a278-274a0e8f000e@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
> First, Thank you very much to the individuals that were actually
> interested in helping find and isolate the problem.
> I very much apppreciated your suggestions!
>
> The problem was an intermittent short between the power wire and one
> of the signal wires behind the wall.
> This cable cannot be replaced due to the location so I will either
> need to relocate the sensor or go to a wireless
> PIR.    Im sure some of you cant wait for me to try to install a
> wireless unit!  :^)
>

If you have three good wires then you can still hook up the motion.
Connect the two power wires to the motion
Conect the hi zone  to the NC terminal on the motion
Use a short length of wire to connect the common terminal and the negative
power terminals in the motion together.

Doug