Re: Vista 20 and IR motion problem

["Mark Leuck" <mleuck@xxxxxxxxx>]

<rickm@xxxxxxxxxxxxxx> wrote in message
news:0dc93313-e6cb-489b-9481-76df6ff62c76@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
On Apr 29, 9:56 pm, "Mark Leuck" <mle...@xxxxxxxxx> wrote:
> <ri...@xxxxxxxxxxxxxx> wrote in message
>
> news:5c28aa30-ecb6-4195-b574-8b297cdb74f0@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> On Apr 29, 9:17 pm, Roger W <alluc...@xxxxxxx> wrote:
>
>
>
>
>
> > On Apr 29, 11:18 pm, ri...@xxxxxxxxxxxxxx wrote:
>
> > > The Vista 20P door sensors work great but the IR motion does not. If
> > > its set to N/C then the system does
> > > not come ready however its set to N/O then it does which of course is
> > > wrong. The programmng summary
> > > looks like this:
>
> > > ZN ZT P RC HW : RT
> > > 05 04 1 10 NC 1
>
> > > The motion detect was working on the old Ademco 4030 panel and the LED
> > > lights with movement. Ive read
> > > through the manual cover to cover as well as the programming guide
> > > many times and motion detectors are
> > > not even mentioned.
>
> > > Any suggestions would be greatly appreciated
>
> > Sounds like you have defective wiring or most likely a defective
> > motion.
> > Wire up the Aurora and if your problem clears, you'll know what to do.-
> > Hide quoted text -
>
> > - Show quoted text -
>
> I removed one wire from the sensor, closed the tamper switch and it
> read about 7ohms
> with no movement and no LED, infinite with movement and LED lite.
>
> Next I reconnected the sensor and repeated the test at the panel with
> both wired removed. It read
> about 185 ohms and then infinite with movement.
>
> If I check the voltage, there is about 13V across the terminals
> regardless of movement.
>
> Walk away and get someone who knows what they are doing, you obviously
> don't- Hide quoted text -
>
> - Show quoted text -

what is wrong with this post and isnt that what this group is for?

I believe I already stated what was wrong, you don't know what you are
doing, a typical DIY'er