Re: Vista 20 and IR motion problem

[Jim <alarminex@xxxxxxx>]

On Apr 30, 9:11=EF=BF=BDpm, "Doug" <n...@xxxxxxxx> wrote:
> <ri...@xxxxxxxxxxxxxx> wrote in message
>
> news:a2a1fd80-bd10-409d-a278-274a0e8f000e@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
>
>
> > First, Thank you very much to the individuals that were actually
> > interested in helping find and isolate the problem.
> > I very much apppreciated your suggestions!
>
> > The problem was an intermittent short between the power wire and one
> > of the signal wires behind the wall.
> > This cable cannot be replaced due to the location so I will either
> > need to relocate the sensor or go to a wireless
> > PIR. =EF=BF=BD =EF=BF=BDIm sure some of you cant wait for me to try to i=
nstall a
> > wireless unit! =EF=BF=BD:^)
>
> If you have three good wires then you can still hook up the motion.
> Connect the two power wires to the motion
> Conect the hi zone =EF=BF=BDto the NC terminal on the motion
> Use a short length of wire to connect the common terminal and the negative=

> power terminals in the motion together.
>
> Doug

Oh, oh! ............... now ya did it!