Re: Vista 20 and IR motion problem

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

Hey...that's a 300$ trick you just gave out.
You'll never work in this town again.


--
**Crash Gordon**







"Doug" <not@xxxxxxxx> wrote in message
news:cF9Sj.107135$497.53744@xxxxxxxxxxxxxxx
>
>
>
> <rickm@xxxxxxxxxxxxxx> wrote in message
> news:a2a1fd80-bd10-409d-a278-274a0e8f000e@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>>
>> First, Thank you very much to the individuals that were actually
>> interested in helping find and isolate the problem.
>> I very much apppreciated your suggestions!
>>
>> The problem was an intermittent short between the power wire and one
>> of the signal wires behind the wall.
>> This cable cannot be replaced due to the location so I will either
>> need to relocate the sensor or go to a wireless
>> PIR.    Im sure some of you cant wait for me to try to install a
>> wireless unit!  :^)
>>
>
> If you have three good wires then you can still hook up the motion.
> Connect the two power wires to the motion
> Conect the hi zone  to the NC terminal on the motion
> Use a short length of wire to connect the common terminal and the negative
> power terminals in the motion together.
>
> Doug
>