Re: D5100 & D2071A

["Doug" <not@xxxxxxxx>]

"ABLE_1" <royboynospam@xxxxxxxxxxxxx> wrote in message
news:XuKdnemaLr9odGranZ2dnUVZ_vumnZ2d@xxxxxxxxxxxxxx
> Hey all,
>
> So I am in need of a DATC for a 20+ year old FireLite Panel.  I happened
> to remember that I had a old used D2071A laying on a shelf collecting a
> lot of dust.  So I removed said dust and dug out the old D5100 bar code
> programmer that had even more dust.  I ??thought?? it had the ability to
> program the D2701A communicator.
>
> Stuffed in a new battery and could not figure out how to set up the
> programming.
> I could get the 8112 to come up but that was all.
>
> The online cut sheet for the D2701A says that it is programmed by the
> D5100 and D5200.
>
> So I thought before I dig a deep hole and bury this stuff for some
> archeologist to ponder over in another 100 years I would ask if any
> collective gray matter here new how to make this work.
>
> Actually I would guess that some archeologist might ponder today about the
> strange stripped bars on the front surface. :-)
>
> So............................ Wadda yaw think???  Bury the sucker or does
> it have hope??
>
> Thanks,
>
> Les

It sounds like the only handlers you have in your 5100 are for an 8112. If
you have the handler booklet for the D2071A  then you can scan them into the
5100 and use it to program the 2071.


Doug