D5100 & D2071A

["ABLE_1" <royboynospam@xxxxxxxxxxxxx>]

Hey all,

So I am in need of a DATC for a 20+ year old FireLite Panel.  I happened to
remember that I had a old used D2071A laying on a shelf collecting a lot of
dust.  So I removed said dust and dug out the old D5100 bar code programmer
that had even more dust.  I ??thought?? it had the ability to program the
D2701A communicator.

Stuffed in a new battery and could not figure out how to set up the
programming.
I could get the 8112 to come up but that was all.

The online cut sheet for the D2701A says that it is programmed by the D5100
and D5200.

So I thought before I dig a deep hole and bury this stuff for some
archeologist to ponder over in another 100 years I would ask if any
collective gray matter here new how to make this work.

Actually I would guess that some archeologist might ponder today about the
strange stripped bars on the front surface. :-)

So............................ Wadda yaw think???  Bury the sucker or does
it have hope??

Thanks,

Les