Re: Vista 20 and IR motion problem

["Mark Leuck" <mleuck@xxxxxxxxx>]

<rickm@xxxxxxxxxxxxxx> wrote in message
news:5c28aa30-ecb6-4195-b574-8b297cdb74f0@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
On Apr 29, 9:17 pm, Roger W <alluc...@xxxxxxx> wrote:
> On Apr 29, 11:18 pm, ri...@xxxxxxxxxxxxxx wrote:
>
>
>
>
>
> > The Vista 20P door sensors work great but the IR motion does not. If
> > its set to N/C then the system does
> > not come ready however its set to N/O then it does which of course is
> > wrong. The programmng summary
> > looks like this:
>
> > ZN ZT P RC HW : RT
> > 05 04 1 10 NC 1
>
> > The motion detect was working on the old Ademco 4030 panel and the LED
> > lights with movement. Ive read
> > through the manual cover to cover as well as the programming guide
> > many times and motion detectors are
> > not even mentioned.
>
> > Any suggestions would be greatly appreciated
>
> Sounds like you have defective wiring or most likely a defective
> motion.
> Wire up the Aurora and if your problem clears, you'll know what to do.-
> Hide quoted text -
>
> - Show quoted text -

I removed one wire from the sensor, closed the tamper switch and it
read about 7ohms
with no movement and no LED, infinite with movement and LED lite.

Next I reconnected the sensor and repeated the test at the panel with
both wired removed. It read
about 185 ohms and then infinite with movement.

If I check the voltage, there is about 13V across the terminals
regardless of movement.



Walk away and get someone who knows what they are doing, you obviously don't