[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]
Re: Intellisense FG-730 on Napco P3200
According to your answer, I do not think you know anything about alarm
system. so do not try to be smart.
"Jim" <alarminex@xxxxxxx> wrote in message
news:1190349028.739700.238650@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> On Sep 20, 11:13?pm, "t nguyen" <tnmissi...@xxxxxxxxx> wrote:
>> Hello, I have installed a FG-730 on Napco p3200 with the following
>> parameters
>> NC loop with default 750ms response.
>> programmed zone as 24 hr zone
>> did not connect any wires to the tamper terminal
>>
>> Everything was looking fine until I tested that glassbreak sensor with
>> C&K
>> simulator. The alarm went off as expected but after I disarmed the
>> system,
>> the panel was still in alarm condition on the glassbreak zone. The
>> keypad
>> displayed as system ready but the siren still went off. Not sure what is
>> going here. Could it be bad FG-730 or I did not program the panel
>> correctly? I tried to change the zone type to a normal burg zone (not 24
>> hr) then it was ok.
>>
>> Thank you for your help
>
> I can't imagine what else you might think a 24 hour zone is .....
> other than ......
> a zone that will go into alarm 24 hours a day.
>
>
> A 24 hour zone, means just that ................
> The system will go into an alarm condition, 24 hours a day whether the
> system is armed or not.
>
>
> (Note: to ASA)
> See new thread on RSQ's
>
>
alt.security.alarms Main Index |
alt.security.alarms Thread Index |
alt.security.alarms Home |
Archives Home