Intellisense FG-730 on Napco P3200

["t nguyen" <tnmissilen@xxxxxxxxx>]

Hello, I have installed a FG-730 on Napco p3200 with the following
parameters
 NC loop with default 750ms response.
 programmed zone as 24 hr zone
 did not connect any wires to the tamper terminal

Everything was looking fine until I tested that glassbreak sensor with C&K
simulator.  The alarm went off as expected but after I disarmed the system,
the panel was still in alarm condition on the glassbreak zone.   The keypad
displayed as system ready but the siren still went off.  Not sure what is
going here.  Could it be bad FG-730 or I did not program the panel
correctly?  I tried to change the zone type to a normal burg zone (not 24
hr) then it was ok.

Thank you for your help