Re: Intellisense FG-730 on Napco P3200

[Jim <alarminex@xxxxxxx>]

On Sep 20, 11:13?pm, "t nguyen" <tnmissi...@xxxxxxxxx> wrote:
> Hello, I have installed a FG-730 on Napco p3200 with the following
> parameters
>  NC loop with default 750ms response.
>  programmed zone as 24 hr zone
>  did not connect any wires to the tamper terminal
>
> Everything was looking fine until I tested that glassbreak sensor with C&K
> simulator.  The alarm went off as expected but after I disarmed the system,
> the panel was still in alarm condition on the glassbreak zone.   The keypad
> displayed as system ready but the siren still went off.  Not sure what is
> going here.  Could it be bad FG-730 or I did not program the panel
> correctly?  I tried to change the zone type to a normal burg zone (not 24
> hr) then it was ok.
>
> Thank you for your help

I can't imagine what else you might think a 24 hour zone is .....
other than ......
a zone that will go into alarm 24 hours a day.


A 24 hour zone, means just that ................
The system will go into an alarm condition, 24 hours a day whether the
system is armed or not.


(Note: to ASA)
 See new thread on RSQ's