Re: Radionics D5200 Programmer

["Just Looking" <nospam@xxxxxxxxxx>]

RPS is up to version 5.5 I believe. If you are programming only G series
panels (D7212G, D7212GV2, D7412G, D7412GV2, D9412G, D9412GV2) you need the
software, the software dongle, a DX4010i, or a DX4020 for local connection
or a SecurComm or a StarComm modem for remote connection.
Attending a class on the G series panels and RPS wouldn't hurt either.
"Silicon Sam" <SiliconSam@xxxxxxxxx> wrote in message
news:1184258613.120239.290570@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> On Jul 10, 9:06 am, "Roland More" <NoSpamrol...@xxxxxxxxxxxx> wrote:
> > What panels are you trying to program? If you have a laptop I'd spend
the
> > money on RPS software and a 4010i instead of a 5200. It is a real pain
to
> > program a panel with a 5200 versus RPS software.
> >
> > "T.J." <super232...@xxxxxxxxx> wrote in message
> >
> > news:1184027563.093511.280300@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> >
> > >  Does anybody know a good place where I can buy a D5200 Programmer
> > > and about how much it would cost? Thanks!
>
>   I have RPS on my laptop (not sure which version, 2.something) and
> have an Enhanced Direct Connect module I used on 7412 and 9412 panels
> a while back.  What do I need to buy to be able to program and connect
> to the newer Bosch panels they sell?  I haven't done any burg panels
> in quite a while, I've been doing nothing but access panels and CCTV
> lately.
>
> Raymond
>