Re: Radionics D5200 Programmer

[Silicon Sam <SiliconSam@xxxxxxxxx>]

On Jul 12, 1:22 pm, "Just Looking" <nos...@xxxxxxxxxx> wrote:
> RPS is up to version 5.5 I believe. If you are programming only G series
> panels (D7212G, D7212GV2, D7412G, D7412GV2, D9412G, D9412GV2) you need the
> software, the software dongle, a DX4010i, or a DX4020 for local connection
> or a SecurComm or a StarComm modem for remote connection.
> Attending a class on the G series panels and RPS wouldn't hurt either."Silicon Sam" <Silicon...@xxxxxxxxx> wrote in message
>
> news:1184258613.120239.290570@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
> > On Jul 10, 9:06 am, "Roland More" <NoSpamrol...@xxxxxxxxxxxx> wrote:
> > > What panels are you trying to program? If you have a laptop I'd spend
> the
> > > money on RPS software and a 4010i instead of a 5200. It is a real pain
> to
> > > program a panel with a 5200 versus RPS software.
>
> > > "T.J." <super232...@xxxxxxxxx> wrote in message
>
> > >news:1184027563.093511.280300@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
> > > >  Does anybody know a good place where I can buy a D5200 Programmer
> > > > and about how much it would cost? Thanks!
>
> >   I have RPS on my laptop (not sure which version, 2.something) and
> > have an Enhanced Direct Connect module I used on 7412 and 9412 panels
> > a while back.  What do I need to buy to be able to program and connect
> > to the newer Bosch panels they sell?  I haven't done any burg panels
> > in quite a while, I've been doing nothing but access panels and CCTV
> > lately.
>
> > Raymond

  I have the software and dongle.  And I've been to a 7412G/9412G
class a few years ago.  Guess I need to try find either a modem or the
local connection module then.  I wanna say we've sold a few 6412
panels lately.  Same direct connect module then?