Re: Moose Z1100 Dialing Problem

["Robert L Bass" <RobertLBass@xxxxxxxxxxx>]

Is this a standard Z1100, a system II or a IIe?  Programming addresses
vary.

--

Regards,
Robert L Bass

=============================>
Bass Home Electronics
941-925-8650
4883 Fallcrest Circle
Sarasota · Florida · 34233
http://www.bassburglaralarms.com
=============================>


>I figured out how to read back what was programmed. (Close the
> programming switch, hit 0 after power up, then a 3-digit address.
> From there, hit pound and it will sequence through the addresses.
> The 8 LEDs give the programmed value in binary as the manual
> describes.)  It appears that there are no telephone numbers
> programmed, and it is just picking up and doing nothing. I did not
> have a chance to reprogram, but I did read all the values and will
> try to do a factory reset and then reprogram. I need to do the reset
> because the programming code was overwritten somewhere along the path.