Re: NAPCO NO LONGER REPLACING KNOWN DEFECTIVES

["Russell Brill" <russwbrill@xxxxxxxxxxxxx>]

"Jim" <alarminex@xxxxxxx> wrote in message
news:1128133340.145906.317190@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
> Russell Brill wrote:
>> Bob,
>>
>> When programming any of the Napco Gemini panels to use Ademco Point ID,
>> what
>> value do you enter in locations like keypad Panic... Is it like the old
>> Moose stuff, enter any value in the reporting location to enable
>> reporting
>> in Point ID, leave blank if reporting is NOT desired... Regards, Russ
>>
> You don't enter anything at those locations. They're only for when you
> are using a digital format.

So you can't send things like Low Battery, AC Fail, etc... etc... if you use
Point ID with the Gemini controls???

 To enable Point ID, just indicate that in
> the format choice area and in the zones area, there's a box where you
> choose what type of zone each is. I'm presuming that you're using the
> Quickloader program.

Yes, I will be.... I was just converted to Napco...
>
> If you're hand programing at the keypad, I can't help you.
>