Re: Radionics D7212B1 Panel Help

["Jim Rojas" <jrojas@xxxxxxxxxxxx>]

I can remote download your panel and see what is wrong with it.

Jim Rojas


"WYSIWYG" <nospam@xxxxxxx> wrote in message
news:FPx6f.1201$8W.595@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>I recently purchased a Radionics D7212B1 panel from my local surplus store
> in the hopes of building a simple, non-monitored alarm for my house. The
> board is dated 9743 and numbered 7212. The EPROM on the board is labeled
> (C)
> Radionics 1995, D7212B1 U4, 26-06962-0316. The Lithium back up battery was
> shot (<0.5Vdc) so I replaced it with a fresh one. The board seems to power
> up and run. It beeps, the LEDs blink, it seems to respond to a battery
> being
> attached, it answers incoming calls, data and power appears to be on the
> Peripheral device connection pins. However, when I connect a D1255 panel
> to
> it, the panel displays "Call For Service" about a minute after power on.
> The
> manual says this means no communication is established between the D7212
> and
> the D1255. Is there something I need to do to get this to work so I can
> use
> it?
>
> Thanks.
>
> Bob
>
>