[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Connecting 4-wire smokes to Ademco V15P

Subject: Re: Connecting 4-wire smokes to Ademco V15P
From: "rahouston@xxxxxxxxxxx" <rahouston@xxxxxxxxx>
Date: 29 Aug 2005 17:00:51 -0700
Newsgroups: alt.security.alarms
References: <1125309971.914230.53570@xxxxxxxxxxxxxxxxxxxxxxxxxxxx> <_OEQe.6$SH1.2213@xxxxxxxxxxxxxxx> <1125335433.091125.311970@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>

So, for the experts, I have one more question------if I decide to
install new 2-wire smokes instead, do they always have to be connected
to Zone 1 on the Vista 15P panel?  The installation instructions
suggest this, but I always thought they could be installed on any zone
that allows programming of a fire zone, as long as the correct polarity
is observed.

Your clarification is very much appreciated!

Rob

Follow-Ups:
- Re: Connecting 4-wire smokes to Ademco V15P
  - From: Crash Gordon

References:
- Connecting 4-wire smokes to Ademco V15P
  - From: rahouston@xxxxxxxxxxx
- Re: Connecting 4-wire smokes to Ademco V15P
  - From: Crash Gordon
- Re: Connecting 4-wire smokes to Ademco V15P
  - From: rahouston@xxxxxxxxxxx

Prev by Message: Re: Adding a third keypad to a Caddx NX-8, wiring help requested!
Next by Message: Re: need unbiased advice about lynx system
Previous by thread: Re: Connecting 4-wire smokes to Ademco V15P
Next by thread: Re: Connecting 4-wire smokes to Ademco V15P
Index(es):
- Message
- Thread

alt.security.alarms Main Index | alt.security.alarms Thread Index | alt.security.alarms Home | Archives Home