The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: xPL Hubs


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: HV Macro runs multiple times


  • Subject: Re: HV Macro runs multiple times
  • From: "gmotichka" <gmotichka@xxxxxxxxxxxxx>
  • Date: Sat, 04 Dec 2004 19:25:54 -0000



Yes, I get multiple messages in the xPL monitor. It usually shows 3
instances - yet the macro executes up to 6 times.

George





--- In ukha_xpl@xxxxxxx, "Frank Mc Alinden" <fmcalind@b...>
wrote:
> > I am getting very close on this working. I now have it where the
x10
> > signal is recognized by the W800 and then triggers the macro in
> > HomeVision.
>
> Good news.......
>
> > The problem is that it will execute the macro multiple times --
> > anywhere from 3 to 6 times consecutively. I can see the multiple
> > commands going to HV. I tried to add a 'macro disable"
command in
> > the macro, but that did not help. Neither did adjusting the
ddespeed
> > or lastsent options in the configuration
>
> Are you receiving multiple message in xPL Monitor ?? when you
press a button
> on your rf remote ???......If so The w800-app might require a
built in delay
> ....Hopefully Mal will post regarding the app.......
>
> Frank
>
>
> ----- Original Message -----
> From: "gmotichka" <gmotichka@h...>
> To: <ukha_xpl@xxxxxxx>
> Sent: Sunday, December 05, 2004 5:20 AM
> Subject: [ukha_xpl] HV Macro runs multiple times
>
>
> >
> >
> > I am getting very close on this working. I now have it where the
x10
> > signal is recognized by the W800 and then triggers the macro in
> > HomeVision.
> >
> > The problem is that it will execute the macro multiple times --
> > anywhere from 3 to 6 times consecutively. I can see the multiple
> > commands going to HV. I tried to add a 'macro disable"
command in
> > the macro, but that did not help. Neither did adjusting the
ddespeed
> > or lastsent options in the configuration.
> >
> > Further suggestions would be welcomed.
> >
> > Thanks
> > George
> >
> >
> >
> >
> >
> >
> > xPL Links: http://www.xplproject.org.uk http://www.xplhal.com
> http://www.xpl.myby.co.uk
> > To Post a Message: ukha_xpl@xxxxxxx
> > To Subscribe:  ukha_xpl-subscribe@xxxxxxx
> > To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
> >
> >






xPL Main Index | xPL Thread Index | xPL Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.