The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: HV Macro runs multiple times




> I am getting very close on this working. I now have it where the x10
> signal is recognized by the W800 and then triggers the macro in
> HomeVision.

Good news.......

> The problem is that it will execute the macro multiple times --
> anywhere from 3 to 6 times consecutively. I can see the multiple
> commands going to HV. I tried to add a 'macro disable" command in
> the macro, but that did not help. Neither did adjusting the ddespeed
> or lastsent options in the configuration

Are you receiving multiple message in xPL Monitor ?? when you press a
button
on your rf remote ???......If so The w800-app might require a built in
delay
....Hopefully Mal will post regarding the app.......

Frank


----- Original Message -----
From: "gmotichka" <gmotichka@xxxxxxx>
To: <ukha_xpl@xxxxxxx>
Sent: Sunday, December 05, 2004 5:20 AM
Subject: [ukha_xpl] HV Macro runs multiple times


>
>
> I am getting very close on this working. I now have it where the x10
> signal is recognized by the W800 and then triggers the macro in
> HomeVision.
>
> The problem is that it will execute the macro multiple times --
> anywhere from 3 to 6 times consecutively. I can see the multiple
> commands going to HV. I tried to add a 'macro disable" command in
> the macro, but that did not help. Neither did adjusting the ddespeed
> or lastsent options in the configuration.
>
> Further suggestions would be welcomed.
>
> Thanks
> George
>
>
>
>
>
>
> xPL Links: http://www.xplproject.org.uk http://www.xplhal.com
http://www.xpl.myby.co.uk
> To Post a Message: ukha_xpl@xxxxxxx
> To Subscribe:  ukha_xpl-subscribe@xxxxxxx
> To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx
> Yahoo! Groups Links
>
>
>
>
>
>
>




xPL Main Index | xPL Thread Index | xPL Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.