The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

HV Macro runs multiple times


  • Subject: HV Macro runs multiple times
  • From: "gmotichka" <gmotichka@xxxxxxxxxxxxx>
  • Date: Sat, 04 Dec 2004 18:20:20 -0000



I am getting very close on this working. I now have it where the x10
signal is recognized by the W800 and then triggers the macro in
HomeVision.

The problem is that it will execute the macro multiple times --
anywhere from 3 to 6 times consecutively. I can see the multiple
commands going to HV. I tried to add a 'macro disable" command in
the macro, but that did not help. Neither did adjusting the ddespeed
or lastsent options in the configuration.

Further suggestions would be welcomed.

Thanks
George






xPL Main Index | xPL Thread Index | xPL Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.