Re: AD10 problem

["Rob Iles" <rob.iles@xxxxxxxxx>]

Methinks it's dead :(

R.I.P AD10!


On 9/20/07, Tim Hawes <timsyahoo@xxxxxxx> wrote:
>
>   Paul,
>
> Yes, no response to an "on", but quiet clicks when either an
"off" is
> sent, or forced off via the front slider. And yes, no output on the
> load terminals.
>
> I presume the module should switch over whether a load is present or
not?
>
> Cheers,
>
> Tim.
>
> On 9/20/07, Paul Gordon
<paul@xxxxxxx<paul%40paulgordon.homeip.net>>
> wrote:
> > That sounds quite like the relay might be stuck in the ON
position... -
> > i.e. not latching... Hence no response to an ON signal, because
it would
> > already be on, and it repeatedly responds to an OFF, because
every time
> > you send an OFF, it switches, but doesn't latch in the OFF
position, and
> > so flicks straight back to ON... - but did you say there's no
output
> > across the load terminals either? - in the above scenario, a load
should
> > always be ON as well, and if it isn't the I guess that's that
theory up
> > the swannee then!....
> >
> > Paul G.
>
>


[Non-text portions of this message have been removed]