Re: AD10 problem

["Tim Hawes" <timsyahoo@xxxxxxxxxxxxxx>]

Paul,

Yes, no response to an "on", but quiet clicks when either an
"off" is
sent, or forced off via the front slider. And yes, no output on the
load terminals.

I presume the module should switch over whether a load is present or not?

Cheers,

Tim.


On 9/20/07, Paul Gordon <paul@xxxxxxx> wrote:
> That sounds quite like the relay might be stuck in the ON position...
-
> i.e. not latching... Hence no response to an ON signal, because it
would
> already be on, and it repeatedly responds to an OFF, because every
time
> you send an OFF, it switches, but doesn't latch in the OFF position,
and
> so flicks straight back to ON... - but did you say there's no output
> across the load terminals either? - in the above scenario, a load
should
> always be ON as well, and if it isn't the I guess that's that theory
up
> the swannee then!....
>
> Paul G.