Re: Photos please - X10 wiring examples

["Tim Hawes" <timsyahoo@xxxxxxxxxxxxxx>]

Thanks Marcus (I do remember your nice dropped ceiling - :-) )

What's the advantage of using a consumer unit over "a bit of DIN rail
in a plain enclosure"? because I don't think you can make use of the
bus bars that would normally run underneath the MCBs if you use X10
modules, can you?

You get the sets of common terminals that you have at the top of your
enclosures, and probably easier access to change fuses/housecodes etc,
but is there anything else?

Cheers,

Tim.


On 8/22/07, Marcus Warrington <marcus.warrington@xxxxxxx> wrote:
> Not the worlds neatest job but here are some pictures of our LD11
> controlled lighting that I retrofitted a few years ago.
>
>
>
> http://www.marcusw.dsl.pipex.com/webalbum/Node0/Node1/index.html
>
>
>
> These are all fitted in the top of a cupboard, under the staircase to
> the attic, on the 1st floor. I ran a single T&E back from each
ceiling
> rose to these consumer units and used one wire to divert the
"switch"
> wire to the LD11 and the other wire then returns the switched live
back
> to the ceiling rose.
>
>
>
> The downstairs dining room, utility and kitchen are controlled from a
> separate consumer unit hidden in the dining room false ceiling.
>
>
>
> http://www.marcusw.dsl.pipex.com/webalbum/Dining%20Room/slides/CIMG0672.
> html
>
>
>
> if that picture doesn't make much sense its probably because the
ceiling
> is a suspended dropped ceiling inset from the edges of the room.
Here's
> a picture that may make it clearer.
>
>
>
> http://www.marcusw.dsl.pipex.com/webalbum/Dining%20Room/slides/CIMG0674.
> html
>
>
>
> Marcus
>
> ________________________________
>
> From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf
> Of Tim
> Sent: 21 August 2007 23:12
> To: ukha_d@xxxxxxx
> Subject: [ukha_d] Photos please - X10 wiring examples
>
>
>
> It's coming to the point where I need to put some X10 modules into
> consumer
> units and I was wondering if anyone had some picture of their own
> efforts
> that they'd like to share.
>
> I thought I had a few links saved up, but the old sites are either
dead,
> or
> I can't find the emails I thought I remembered.
>
> Someone, I know, had three-off triple rail cabinets stuffed full of
> modules,
> I just can't remember who, or whether it showed the internal wiring as
> well.
>
> I did find a few CBus installs but was really after X10. Can anyone
> oblige?
>
> Many thanks,
>
> Tim.