The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: [Slightly OT Contd...] - UPS Calibration.



I had a problem like this with the same model (although not when it
was calibrating, this was under normal circumstances). I figured the
batteries were on the way out and replaced them. The problem remained,
so that was a waste of money!

Bascially it seemed that whilst the 2200 circuitry can handle a load
of up to 100% (2200W, iirc) on the scale, the batteries inside can't
sustain that 100% load for very long. Like you i had about 40% load,
and the run time was short- about 15-17 minutes.

Wait for an UPC experts opinion, but you can get a battery case to
daisy chain more batteries to the 2200, which will increase the run
time at higher loads. I ended up buying a second UPS with 2 battery
packs. the 2200 now does lighter duties, but is working fine.


On 5/18/05, Phil Harris <phil@xxxxxxx> wrote:
> Tried doing a recalibrate on this APC2200 at about 9:30 last night
using a
> 47%(ish) load (according to PowerChute) as I was still getting the
right
> hand side battery display flashing when I came back to it after
> recalibrating the evening before.
>



UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.