[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
RE: LD11 preset question (with Homeseer)
- To: <ukha_d@xxxxxxx>
- Subject: RE: LD11 preset question (with Homeseer)
- From: "Kenneth Watt" <kennwatt@xxxxxxx>
- Date: Wed, 20 Feb 2002 14:03:22 -0000
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
>
> I have tested and verified this morning that I CAN get an LD11 to come
on
> instantly at 100% bright, with no ramp up from off. - I can only do
this
> for
> the 100% level though, - any other level selected soft starts from 0%.
K.> Yep, AFAIK, that is totally correct.
>
> This is using Homeseer with the LD11 device configured as Leviton dim.
> either from the GUI or from a script, if I send it a "Dim to
100%"
command
> whilst it is switched OFF, i goes instantly to full brightness. If it
is
> already ON, and at some other brightness, then it ramps IIRC.
K.> Yep, again totally correct.
>
> Oh, and I can only get it to do it via an X10 command of course! - I
want
> to
> be able to replicate the same functionality from the local control,
but I
> don't think its possible...
With momentary contact closure to an LD11 you should get the module to
ramp up to the last level that the module was set to from 0% (off) and
the same would happen in reverse for off IIRC.
You can get local control and make the module behave any way you like
but only by using a Leviton switch, which is what I did in three
locations. They are really small X10 transmitters and have proved really
good but there are downsides. One is that they are US sized so a
standard backbox cannot be used and the other is it needs a neutral.
HTH
K.
Home |
Main Index |
Thread Index
|