XM11U can't drive relay. Fixable?

[justin@xxxxxxx]

Some time ago I purchased a XM11U (X10 controlled 12v power supply) to
drive a 
relay (http://www.quasarelectronics.com/relays.htm
part 3084). It seems that at 
100mA the XM11U doesn't have enough power(?) to drive it. A regular PSU
rated 
at 500mA works ok.

Baring in mind I'm not too clued up on electronics, is there anything that
could be done remidy this? Perhaps add something between the two devices or
change a component on the relay board?

Justin.

Yahoo! Groups Sponsor

ADVERTISEMENT

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.