[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

Re: Surveillance camera wiring



On Nov 3, 5:04 pm, Frank Olson
<use_the_email_li...@xxxxxxxxxxxxxxxxxxxxxx> wrote:
> betty wrote:
> > My intent was to set up a surveillance camera and put it on one of my
> > cable channels to view it.  I know I need to get some sort of
> > modulator or even get it built in like the ones Net Media offers.
>
> > I have some questions though about the video signal.  A camera such as
> > the Sanyo vcc-4794 has a BNC connector for the video output.  I was
> > planning to connect this to a coax cable to bring it from my garage to
> > my house.  Is this signal  from the camera the same as the video
> > component of RCA cables?
>
> > Is a coax cable the best choice or should I just run a single wire
> > equivalent to the RCA video wire?   Many of the modulators take in RCA
> > and put them on coax but I just want to make sure I buy the right
> > stuff.
>
> > Any information would be great.
>
> The output on a BNC can be converted to an RCA with no problem (there
> are adapters you can buy that work well (with very little in the way of
> signal loss).  It's best to buy a good quality Coax for the run from the
> camera to where-ever it is you're going to hook it up to.  RG-6 would
> work well (and is readily available).  RG-59U is also a good choice but
> more expensive.  Good luck!

Huh?  RG6 is almost invariably more costly than RG59.  Professional
installers have been using RG59 for CCTV systems for years.  If you
were using high definition (HDTV) cameras you'd need to use RG6,
preferably quad shielded. However, it is highly unlikely you'll find a
need for HD in a typical surveillance project.

--

Regards,
Robert L Bass
Bass Home Electronics
www.BassBurglarAlarms.com



comp.home.automation Main Index | comp.home.automation Thread Index | comp.home.automation Home | Archives Home